The Buggy assembler, disassembler, monitor, debugger by Lennart Benschop for the SBC09 single-board computer, adapted to the SST-6809
Connect the SST-6809 USB-C to a USB port on your Debian machine.
Verify the status LED is lit blue.
On Debian, install the minicom serial terminal program:
$ sudo aptitude install minicom
Run minicom and specify your USB device:
$ minicom -D /dev/ttyUSB0
Configure the minicom terminal timings:
CTRL+A T Choose D and enter 1 for 1ms newline delays Choose F and enter 1 for 1ms character delays Press ENTER to exit the terminal configuration menu
At the ASSIST09 “>” prompt, start a [L]oad:
>L [ENTER]
Paste the Buggy S-records file from minicom into the SST-6809:
CTRL+A Y [Go To] the folder you saved the S19 file to. [SPACE] to select the S19 file itself [ENTER]
Now wait (a while!) until you see “>00” for successful load or “?” for a failed load.
You *may* need to press [ENTER] once during the load which should eventually trigger the “>00” end of load notice.
At the ASSIST09 “>” prompt, start Buggy with a [C]all to B400:
C B400 . .h for help
Return to SST-6809