BUGGY 1.01 for the SST-6809

The Buggy assembler, disassembler, monitor, debugger by Lennart Benschop for the SBC09 single-board computer, adapted to the SST-6809

Manual

Assembler Source

Assembled Listing

S-Record File

Debian Quick Start

Connect the SST-6809 USB-C to a USB port on your Debian machine.

Verify the status LED is lit blue.

On Debian, install the minicom serial terminal program:

$ sudo aptitude install minicom

Run minicom and specify your USB device:

$ minicom -D /dev/ttyUSB0

Configure the minicom terminal timings:

CTRL+A T 
Choose D and enter 1 for 1ms newline delays
Choose F and enter 1 for 1ms character delays
Press ENTER to exit the terminal configuration menu

At the ASSIST09 “>” prompt, start a [L]oad:

>L [ENTER]

Paste the Buggy S-records file from minicom into the SST-6809:

CTRL+A Y
[Go To] the folder you saved the S19 file to.
[SPACE] to select the S19 file itself
[ENTER]  

Now wait (a while!) until you see “>00” for successful load or “?” for a failed load.

You *may* need to press [ENTER] once during the load which should eventually trigger the “>00” end of load notice.

At the ASSIST09 “>” prompt, start Buggy with a [C]all to B400:

C B400
.
.h for help

Return to SST-6809

This website uses cookies. By using the website, you agree with storing cookies on your computer. Also you acknowledge that you have read and understand our Privacy Policy. If you do not agree leave the website.More information about cookies